A commercial extraction fan is designed to help with poor ventilation.

Always take note of the Building Regulations

Building Regulations require the installation of mechanical ventilation in all kitchens, bathrooms and toilets. Commercial Extraction Fans should always be located as high as possible (a minimum of 1.8m from the floor) in the window or wall nearest to the steam or smell source, but not directly above a cooker hood, cooking hob or grille. They should be positioned as far away as possible from the main source of air replacement. A commercial extractor fan, unlike a cooker hood, does not have an integrated particle filter, which prevents fatty deposits building up in the ducting. It should only be used as an additional source of ventilation in a kitchen. If there is a gas heater or boiler in a room it must have sufficient ventilation when the extractor fan is running. Inadequate ventilation could result in toxic fumes being drawn down the flue into the room.

There are two basic fan types to choose from: Axial; these fans are designed to move air over short distances only, and are therefore suitable for window fixing or “through the wall” applications. They are not suitable for ducting runs in excess of 2 metres or in an exposed or high-rise position where wind can create extra resistance. If in doubt fit a centrifugal type.

Centrifugal; these fans are designed to move air over longer distances, and will perform well against the resistance presented by longer lengths of ducting. Traditionally fitted with higher specification motors, they also provide longer life.

To select the correct commercial extractor fan, calculate the volume of the room in cubic metres (length x width x height). Multiply by the number of air changes (the cubic volume of air removed and replaced) per hour. The minimum number of air changes needed per hour is 10-15 for utility rooms, 10 for kitchens and 3 for living rooms. In bathrooms, showers and toilets, regulations require the fan to be fitted with a timer giving a 15 minute over-run after the room has been vacated. This is usually achieved by operating the extractor fan via the light switch.

Modern kitchen ventilation is achieved using a cooker hood, however on occasion extra ventilation is required. Building regulations stipulate that you need a larger fan in kitchens. While most bathroom fans have a 100mm spigot (the diameter of the air outlet on the back), kitchen fans tend to have a 150mm diameter spigot.

Fans can vent to the outside world in one of three ways – wall, window or ceiling. Not all commercial extraction fans can be mounted in all ways so it is always best to check which solution is best for your circumstances.

Fans need to have special attention paid to them when being installed. In recognition of this, Part P of the Building Regulations came into effect in 2005 and covers the installation of electrical appliances in the home. It stipulates that the householder can undertake small replacement jobs such as electrical sockets or light switches but for places considered ‘high risk’ – e.g. wet rooms, such as bathrooms – special consideration must be given. A qualified electrician who is registered under the Part P self-certification scheme must carry out this electrical work.

TurboProp High Pressure Axial Fans

Black Sabre Slim Case Sickle